Our Integrity Roofing System
In order to protect your roof at the highest level, Integrity Roofing and Painting, LLC exceeds manufacturer’s requirements with our installation. The Integrity Roofing System is a component based roof replacement system. Every damaged roof component is replaced and all integral roof components are replaced. As a Colorado roofing company, we understand that your roof is only as strong as the weakest component- it’s more than just the shingles. It will be put to the challenge in our extreme weather patterns.
The following steps comprise the Integrity Roofing System:
- INSTALL YARD SIGN
The sign needs to be installed before the adjuster meeting and all the way through the roof installation, unless prohibited by the HOA. It alerts the insurance adjuster to damage in the area. It confirms the right address for delivery drivers and installers. It serves as a “stop sign” to notify other roofers to avoid knocking on your door.
- PRE-CONSTUCTION CHECKLIST
We will have you confirm shingle selection and color. Review any potential upgrades. Your project manager will cover precautions to protect your property and safety rules with you before we begin.
Integrity Roofing and Painting will pull the appropriate permits before the roof replacement begins.
- DELIVER MATERIALS
Materials will be placed on the roof unless other arrangements have been made.
- PROTECT THE LANDSAPING AND DECKING
When needed and logistically practical, we will cover landscaping, hot tubs, and decking prior to the removal of the existing roof.
- REMOVE OLD SHINGLES AND FELT PAPER
Integrity Roofing and Painting, LLC will tear off and haul off old shingles, valley metal, drip edge, and rubber boots.
- ICE AND WATER SHIELD
This is a modified bitumen self adhering and self healing product designed to seal critical areas from water penetrations. It actually swells up and reseals itself around nail penetrations.
- FELT UNDERLAYMENT
All roofing underlayment is to be installed horizontally. Along the bottom perimeter, the felt paper will be installed over the metal eave. Along the rake edge, the felt paper is installed before the metal eave.
- WINDSTORM STARTER STRIP (There is no comparison)
We upgrade your roof to a windstorm starter strip at no cost to you.
- WALL ABUTMENTS
Integrity Roofing and Painting, LLC installs ice/water shield along walls, chimneys and skylights.
- VALLEY FLASHING
We install ice/water shield or metal in the valleys.
- PIPE FLASHING/VENT PIPES (RUBBER BOOTS, LEAD JACKS, 3 IN 1)
New pipe flashing is installed on the roof.
- SHINGLES INSTALLATION
Integrity Roofing and Painting, LLC will install preselected shingles according to manufacturer’s instructions and code requirements.
- HIP AND RIDGE CAP
Matching hip and ridge are installed.
- ROOF VENTILATION (Ridge vents, soffit vents, turbine vents….)
Proper roof ventilation leads to longevity of shingles, while improper roof ventilation decreases life expectancy and can lead to ice dams. Manufacturers’ warranties are voided if the roof is not properly ventilated. This is the ideal time to upgrade your attic ventilation system if needed. The insurance carrier does not pay for upgrades, so this would be an added expense that would be discussed prior to the build. We suggest using a combination of intake and exhaust vents for maximum efficiency.
- ROOF JACKS
All roof jacks come pre-painted or will be painted to match.
- CLEAN UP
Our roof installers will continue to clean the yard while roof debris is being removed. Integrity Roofing and Painting, LLC will deposit debris into our container throughout the entire roof installation. A magnet will be used to pick up nails that are on the ground. We care about your safety and it shows in our attention to details, down to the last ground inspection.
Integrity Roofing and Painting, LLC will schedule local enforcement inspections if required by governing building department. We make sure all building code inspections occur at the proper times. Our Master Certified Installer oversees the roof process to ensure code compliance.